How to Measure SE-CP3010 ultrasonic rangefinder
- Author:Steve
- Source:www.electronic-supplier.com
- Release on:2015-07-17
1. Boot and press the "READ" key again, between the point and measurementrange finder distance will be displayed on the screen.
2. The range finder is flattened to about floor ceiling middle position on the wall.Ensure that between the point and the measured range finder without anybarrier. And to ensure that the front of your head or hand will not stand in therange finder.
Matters needing attention:
The measurement results will continue to show about 30 seconds (or longer if in 30 seconds you press another key).
If you try to measure the distance of less than 2 feet (0.6 meters) or greater than 60 feet (18 meters), "ERROR screen will prompt" (error).
2. The range finder is flattened to about floor ceiling middle position on the wall.Ensure that between the point and the measured range finder without anybarrier. And to ensure that the front of your head or hand will not stand in therange finder.
Matters needing attention:
The measurement results will continue to show about 30 seconds (or longer if in 30 seconds you press another key).
If you try to measure the distance of less than 2 feet (0.6 meters) or greater than 60 feet (18 meters), "ERROR screen will prompt" (error).